NOT on stock

• BigTower case (compatible with E-ATX)
• 1x 5.25" drive bays (external)
• 12x 3.5" Hot Swap drive bay (external)
• 6x 3.5" bays for HDDs (internal)
• Screwless mounting system (HDD/up to 3 ODDs/add-on cards)
• Front I/O with 4x USB2.0, headphone and microphone connectors
• 7 Slots for add-on cards
• Dimensions: 215 x 535 x 540 mm (W x H x D)
• 2 openings for water cooling tubing
• Colors: black
  

• Side panel: 2x 120 mm fans (optional), 2x 80 mm fans (optional)
• Rear panel: 1x 140 mm fan (optional)

• Rebel12 Economy edition
• Manual (8 languages)
• Accessory kit

FanMax fan controller is the ideal device to control and adjust the revolutions of your fans in your whole computer system. You can turn either of the “Cooling Zones” off, when any of them is not necessary. Therefore you can minimize the noise development efficiently.

You can easily set up two different “Cooling Zones”, each of which consists of up to four fans. You can easily switch either “Cooling Zone” on or off , independently or simultaneously, so you can tailor-make two different cooling profiles for your system.

Each connected fan, depending on your settings and requirements, can be precisely adjusted from 6 up to 12 volt input. Whether full or low power performance from your installed fans is all under your control.

FanMax comes with all necessary cables to connect up to 8 fans with standard 3-Pin or PWM connector. All you need is an unused 5.25” bay for your computer case, and you are ready to go.